Function; Setting Flow Time - Franke 7612982245077 Instrucciones De Montaje

10.9 Check the water connections for leaks.
10.10 Remove the small cover plate (j).
10.11 Remove the locking ring (h).
10.12 Remove the pressure cap (g) and spring (f).
10.13 Pull the protective foil off the cover plate.
10.14 Seal the cover plate, e.g. with Chromol (not part of the delivery scope,
see Accessories
10.15 Insert the cover plate (k) into the frame tabs at the top and fit.
10.16 Push on the rosette (l).
10.17 Fasten the cover plate at the bottom, using the screws (m).
10.18 Check the flow time and adjust if necessary (see
10.19 Set the temperature stop (see
☞
Important!
When putting the pressure cap in place, ensure that the tappet engages with the
corresponding groove.
10.20 Fit the spring (f) and pressure cap (g).
10.21 Secure the pressure cap with the locking ring (h).
10.22 Fit the small cover plate (j).

11. Function

Trigger the flow of water
11.1 Press the pressure cap.
• The water will flow.
• The water flow stops automatically once the preset flow time has expired.
Temperature selection

12. Setting Flow Time

12.1 Set the desired temperature of the mixed water.
12.2 Remove the small cover plate.
12.3 Use a screwdriver to set the flow time.
a: Blade width 3 mm
+ longer flow time (max. 35 s)
– shorter flow time (min. 5 s)
12.4 Trigger the tap to measure the flow time.
Chapter 19.).
Chapter
Chapter
13.).
- 6 -
12.).