Operating Instructions - Schumacher Electric PID-200-USB Manual Del Propietário

5.

OPERATING INSTRUCTIONS

1. Connect the inverter (see "CONNECTING INVERT-
ER CABLES" section.
2. Press and hold the ON/OFF switch to turn the
inverter on. (The internal speaker will make a brief
"beep". This is normal.).
3. The digital display turns on to the default display of
"POWER OUT".
4. Press and hold the ON/OFF switch to turn the
inverter off.
5. Make sure the device to be operated is turned OFF.
6. Plug the device into the inverter AC outlet.
7. Turn the inverter on. The Power Out LED will glow
and the digital display will show O.
8. Turn the device on. The display will now show the
total wattage used by the device. To change the digital
display, press the ON/OFF switch.
9. To disconnect, reverse the above procedure.
NOTE: If more than one device is to be powered,
start one device at a time to avoid a power surge and
overloading the inverter. The surge load of each device
should not exceed the inverters Continuous Operation
wattage rate.
ATTENTION: If there is a short circuit or power surge
in the device,  will display and the alarm will sound.
Press the ON/OFF switch to turn off the alarm. If the 
displays after several attempts, there is a short circuit or
the device requires more "starting" or "peak" load than
the inverter is capable of providing.
10 •
•