Honeywell DUAL COMFORT HWC775 Serie Manual Del Propietário página 6

USING YOUR HUMIDIFIER (continued)
HWC778 Humidistat Control
1. Power: Press Power Button
The unit will default to cool mist, high output, and will display
the current room humidity level. Press Power Button
turn off.
If humidifier was programmed before turning off, previous
settings will be remembered. Unplugging the humidifier resets to
default settings.
2. Mist Temperature: Press Cool
toggle between cool and warm mist output settings.
The Mist Output LEDs and light around the Mist Temperature
buttons will be blue when unit is in cool mist mode and orange
when in warm mist mode.
NOTE: Cool mist is immediate but please allow 5 minutes for
water to boil to produce warm mist. It is normal to hear the
sound of the water boiling occasionally as more water drains
into the Boiling Chamber.
3. Mist Output Level: Press the desired Mist Temperature icon to
toggle through low, medium and high (1, 2 or 3 LEDs) mist output settings.
The higher the output setting, the more moisture enters the air.
The lower the output setting, the longer the run time before needing to be refilled.
4. Humidistat: Press the Humidity Control icons
To scroll through the numbers faster, press and hold the icon as long as needed until the desired level is
shown. The display will blink three times showing the SET humidity level, then the display will return to
show the current room humidity level. CURRENT will illuminate on the display to indicate the current room
humidity level.
The humidistat can be set between 30%-69%. Below 30%, LO will illuminate on the display to indicate the
minimum humidity level. Above 69%, the display will show HI to indicate the maximum humidity level has
been set.
NOTE: The % number displayed on the control panel represents the relative humidity (RH) as
measured at the Humidistat sensor. The relative humidity in your room may vary from the number
displayed on the humidifier. A comfortable humidity level is 40-60%.
Humidity Reached (US models only)
When the set humidity level is reached, HUMIDITY REACHED will appear on the display and the humidifier
will turn off. As long as HUMIDITY REACHED is illuminated,
Once the humidity level drops below the set level, HUMIDITY REACHED will disappear and the humidifier
will start running again.
To increase the set humidity level, press the Humidity Control icons
5. Reset: The Reset Light has several functions. See next section for details.
to turn on.
or Warm selectors to
to adjust the humidistat.
6
Humidistat
again to
Mist Output
Level
Temperature
Power
Reset
the humidifier will not run.
.
Mist
HWC778
Humidistat Control