HP Stitch S1000 126in Información De Introducción página 7

Message or code
[Color] cartridge is altered
[Color] cartridge is low on ink
[Color] cartridge is missing
[Color] cartridge is non-HP ink
[Color] cartridge is out of ink
[Color] printhead is missing
[Color] printhead out of warranty
An error has occurred in printhead
detection
Checking file system
Checking printer
Clean drop detector spittoon
Cleaner roll jam
Color calibration canceled because
of scanning errors
Connecting
Connecting printer, please wait
Disconnected
FW upgrade post actions
Ink drying
Ink system not ready to print
Job canceled due to lack of data
received from the IPS
Line sensor calib. error: substrate
too small
Low cleaner roll
Lower lever
6
Recommendation
Replace the cartridge.
Be ready to replace the cartridge soon.
Install the correct cartridge.
You are recommended to install an HP cartridge for best performance.
Replace the cartridge.
Install the correct printhead.
The printhead's warranty has ended, because of the length of time it has
been in operation, because of the volume of ink used, or because non-HP
ink has been used in the system. See the limited warranty document.
Remove the printhead, clean any ink from the electrical connectors on the
printhead (do not try to clean the nozzles), and reinsert the printhead.
After a dirty power off, the printer performs a file system check, which will
take some minutes.
The printer is completing checks and cool-down cycle after finishing a job.
Clean the ink deposits.
Go to the Internal Print Server and select the Ink System menu, then Check
cleaner roll. Pull out the printhead cleaning roll assembly, raise the
pinchwheels, wind the roll forward manually, then lower the pinchwheels
and push the assembly back into the printer.
The color calibration chart could not be scanned successfully with the
current substrate.
The Internal Print Server is connecting to the printer.
The Internal Print Server is starting the printer.
The printer is shut down or not detected.
A firmware update is being performed.
The printer is drying the last passes of a job after printing it.
Please wait a while. If the printer does not recover, restart it.
If the problem persists, check the configuration of the built-in computer,
which runs the Internal Print Server.
Load a larger substrate.
Be ready to replace the printhead cleaning roll soon.
Lower the substrate pressure handles.
ENWW