HP Stitch S1000 126in Información De Introducción página 8

Message or code
Maintenance #N advised. Please
contact HP.
No substrate loaded
Please close safety sensor
Please press rearm button
Please release emergency stop
Preparing to print
Printer cannot carry on printing
Printer cannot cool down
Printer cannot warm up
Printheads not aligned
Printhead replacement incomplete
Printing
Ready
Remove [color] printhead
Replace [color] cartridge
Replace [color] printhead
Replace aerosol filter
Reseat [color] cartridge
Reseat [color] printhead
Select substrate name in the IPS
Starting
Substrate jam: remove substrate
ENWW
Recommendation
You are advised to contact your service representative.
Load substrate.
An open safety circuit has been detected, and should be closed in order to
continue working.
Press the blue, blinking button to finish the printer's start-up procedure.
An emergency button has been pressed, and must be released to continue
working.
The printer is performing checks and warm-up prior to printing.
Check that the three-phase power supply is working and that the ambient
temperature is within the normal range. This problem can also be caused
by holes in the substrate, by reflective or transparent substrates, or by a
dirty or faulty temperature sensor.
If the ambient temperature is within the normal range, this problem may
be caused by removing the substrate too quickly after printing. Try leaving
the substrate in the printer until temperatures settle down after printing.
Check that the three-phase power supply is working. This problem can
also be caused by holes in the substrate, by reflective or transparent
substrates, or by a dirty or faulty temperature sensor.
Align the printheads.
The printhead replacement process was unsuccessful.
The printer is printing.
The printer is ready to receive and print a job.
Remove the printhead.
Replace the cartridge.
Replace the printhead.
Replace both aerosol filters.
Reseat the cartridge.
Reseat the printhead.
Select the name of the loaded substrate in the Internal Print Server.
The printer is being detected while starting up.
Remove all substrate from the printer (see the user guide).
7