Metalux Skyridge Single SRS Instrucciones De Instalación

IB519024EN
Installation Instructions – Skyridge Single (SRS) Luminaire Sensor
Installation
Instructions d'installation – Installation du capteur de luminaire
simple Skyridge (SRS)
Instrucciones de instalación – Instalación del sensor de luminaria
Skyridge Single (SRS)
WARNING
Risk of fire, electrical shock, cuts and or other casualty
hazards. This product must be installed in accordance
with the applicable installation code by a qualified
electrician or a person familiar with the construction
and operation of the product and the hazards involved.
Eaton Lighting assumes no responsibility for claims
brought about by improper or careless installation or
handling of this product.
CAUTION
Edges May Cut. Handle with care.
IMPORTANTe: Read carefully before installing fixture. Retain for future reference.
ATTENTION Receiving Departmente: Note actual fixture description of any shortage or noticeable damage on delivery
receipt. File claim for common carrier (LTL) directly with carrier. Claims for concealed damage must be filed within 15
days of delivery. All damaged material, complete with original packing must be retained.
Tile Mount Ceiling Installation – Lumawatt
Pro
The Lumawatt Pro sensor on the WSR is tile mount only.
It must be located at least 12" from the long axis of the
fixture and up to as far as the 7 ft. cable will allow.
IR signals cannot penetrate the acrylic Waveguide causing
a loss in occupancy coverage. Be sure that placement is
outside the coverage "shadow" of the Waveguide.
The integrated sensor controller is factory wired to the
luminaire, and does not require additional field wiring other
than power. The only connection you are required to make
is connecting the control cable to the back of the sensor.
CAUTION
Risk of burn. Disconnect power and allow fixture to cool
before changing bulb or handling fixture.
WARNING
Risk of Fire and Electric Shock. If not qualified, consult
an electrician.
Green ground screw provided in proper location.
N oticee:
Do not relocate.
N oticee: Minimum 90° supply conductors.
N otee: Specifications and dimensions subject to change
without notice.
Sensor
Brand Logo
reversed out of
black
INS # INS #
Control Cable