DeWalt DW7440 Manual Del Usuario

FIG. 1
FIG. 2
TAB
LANGUETTE
LENGÜETA
Cat. No. DW7440-Type 2 Form No. 153513-02
Heavy Duty Table Saw Stand
DW7440
BE SURE TO OBSERVE ALL OF THE SAFETY INSTRUCTIONS
IN THE TABLE SAW INSTRUCTION MANUAL.
THIS TABLE SAW STAND IS DESIGNED FOR USE WITH THE
DW744 HEAVY DUTY TABLE SAW. DO NOT USE THIS SAW
STAND WITH ANY OTHER TOOL.
• Open saw stand fully before use. See Figure 1.
• Maximum load: 300 lbs. (136kg.)
• Do not climb on or sit on saw stand.
• Do not use saw stand on inclined, uneven or unstable surfaces.
• The back legs of the saw stand are slightly longer than the front
legs to provide additional support. Use the saw stand and
operate the table saw from the front side only.
• Fasten tool to saw stand before use.
• Do not use saw stand if it is damaged or bent.
TO OPEN TABLE SAW STAND:
1. Unfold the saw stand until it is fully opened. Place it upright, as
shown in Figure 1.
2. Place the table saw on the saw stand. Place the tabs on the
OPENING
front of the table saw into the openings on the front of the saw
OUVERTURE
stand, as shown in Figure 2. Ensure the tabs fit snugly into the
ABERTURA
openings. DO NOT mount the table saw to the saw stand in
any other orientation.
3. Fasten the table saw to the saw stand with 1/2" x 1-1/2" bolts
in all four corners.
mounted to saw stand before use.
TO CLOSE TABLE SAW STAND:
1. Remove the four bolts, lift the table saw from the saw stand.
2. Pick the stand up by the top rails and close it.
(MAY99-CD-1) Copyright © 2000 D
English
READ INSTRUCTIONS BEFORE USE
WARNING:
CAUTION: Make sure table saw is firmly
WALT
E
Printed in Canada