Hoppe 7517464 Manual De Instrucciones página 18

Tools required:
Phillips head screw driver
Hex wrench (provided)
Ring wrench (provided)
Pliers (recommended)
Installation:
1. Loosen set screw (C) on knob (D) using the hex wrench provided. Knob designs may vary from
design shown.
2. Remove knob (D) from body of cylinder (B).
3. Align drive tab (J) with the cylinder body to install the cylinder into the lock as shown by (G). If the
drive tab (J) cannot be rotated to this position, push the pin (E) down with the ring wrench (F) to
disengage the stops and turn the cylinder shaft (B) until the drive tab (J) is aligned with the cylinder as
shown by (G).
4. Holding the cylinder in this position, insert the cylinder body into the lock so the drive tab (J) is inside
of the lock.
5. Rotate the shaft (B) (use pliers if necessary) so the top of the shaft (B) moves toward the edge of the
door or insert the key (A) into the cylinder and rotate so the top of the key (A) moves towards the
edge of the door (H). The shaft or key will rotate freely and will stop after approximately 120°. Do
not force rotation. The dead bolt should not extend (exception: dead bolt will extend on single point
gear). Confirm that one of the two set screw openings is positioned on the bottom of the shaft (B).
Warning: If the shaft (B) or key (A) is rotated the wrong direction, the cylinder will lock after
approximately 120° and cannot be rotated in either direction. If this happens, push the pin
(E) down with the ring wrench (F) included to disengage the stops and turn the shaft (b) or
key (A) in the opposite direction until the dead bolt extends.
6. Attach knob (D) on shaft (B) as shown.
7. Tighten set screw (C). Install cylinder screw (K) as shown.
Removal:
1. Loosen and remove cylinder screw (K) and repeat steps 1-4 above.
(J)
(E)
(H)
(B)
Page 18
Installation Instructions
90-Degree Turn Cylinder
Aligned
(B)
(F)
(G)
(K)
(A)
(A)
(H)
(C)
(B)
(D)
(D)
(C)