Oven Light - Whirlpool Acros AF30212 Instructivo De Instalación, Uso Y Manejo

OVEN LIGHT

Some models (see page 2 have an oven light.
Some models have the light switch located on
the left side of the manifold panel. Other models
have the switch integrated on the oven knob, it
turns on when the knob is operated and the light
remains on, allowing to watch the baking at any
time. Other models have an integrated light switch
in front of the oven door and is activated
automatically when the door is opened.
•
How to replace the oven bulb:
1.- Disconnect the power cord.
2.- Remove the bulb and replace with a new 40
watts special appliance bulb.
3.- Connect the power cord again.
NOTE: Connect the range in a wall outlet with a voltage of
127 V ± 10%. Be sure the installation is properly grounded.
SUPER SAFE KNOB
Some models (see page 2) have Super Safe knobs,
these are knobs with a lever that activate an extra
safety mechanism for children. If you do not have
children at home is not necessary to activate the lever
each time you turn off the burners.
The knob can be turned if the lever indicates the
unlock position
position, the knob can not be turned.
IMPORTANT
Once you have turned on the
burner, the lever must be
maintained on unlocked position,
as shown in the figure.
Putting the lever on lock position when the burner
is turned on, may damage or difficulty the operation
of Safety Knob.
• How to install the knobs if you remove them for cleaning:
1.- The valve should be in off position.
2.- The knob should be in vertical position, the red mark
up and the small lever to the left side (See the illustration).
3.- Insert the knob in the valve, be sure that the small pin behind
the knob is aligned to the hole on the manifold panel, push the
knob until the face of the manifold panel.
10
. If the lever indicates the lock
SUPER SAFE KNOB
Unlocked knob
Locked knob
KNOB CAN TURN
KNOB CAN NOT TURN