Bluetooth Connection - Bowers & Wilkins T7 Manual De Instrucciones

Ocultar thumbs Ver también para T7:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20
5. T7 audio inputs
T7 can play audio either wirelessly from a compatible
Bluetooth device or through a wired connection from
a device with an analogue output.
T7 will select between its Bluetooth and wired inputs
automatically although the Bluetooth input has
priority. The following input selection rules apply:
• If T7 is connected via Bluetooth and a plug is
inserted in the Auxiliary input socket, T7 will
switch to the Auxiliary input.
• If T7 is playing audio through its Auxiliary input
and a Bluetooth stream is received or the
Bluetooth button is pressed, T7 will switch to the
Bluetooth input.
• If T7 is playing audio through its Auxiliary input
and the cable is disconnected T7 will switch to
the Bluetooth input and attempt to connect to
the primary paired source device.
Note: If T7 is connected via Bluetooth while an
Auxiliary input cable is also connected, a new
analogue audio signal will not automatically
switch T7 to its Auxiliary input.

5.1 Bluetooth connection

To connect T7 to a Bluetooth enabled audio device it
must first be "paired" with the device. Once paired, a
Bluetooth device and T7 will "remember" each other
and be able to connect when within range.
T7 will remember up to eight paired Bluetooth
devices. The first paired device will be designated
as the "primary" device, additional devices will be
designated as "secondary" devices.
The primary device will be connected when within
range, and the T7 Bluetooth button is pressed.
Secondary devices will not connect automatically
when in range but must be connected via their
Bluetooth settings.
It is possible for two paired devices to be connected
to T7. However, audio will only be heard from one
device at any one time. When two devices are
connected the other device can override the active
stream.
To pair a Bluetooth device with T7 follow the steps
described below.
• With T7 switched on, press and hold the
Bluetooth button for 2 seconds. The indicator
will flash and T7 will provide audible feedback
when it enters "pairing" mode.
Note: T7 will automatically exit from Bluetooth
pairing mode if no device is paired within 5
minutes.
• Open the Bluetooth settings on the source device
and ensure Bluetooth is switched on. Once
discovered, Bowers & Wilkins T7 will appear as
an available Bluetooth device. Select T7 and close
the Bluetooth settings. T7 Bluetooth indicator will
flash as pairing is underway and illuminate fully
when pairing is established. T7 will also provide
audible feedback when pairing is established.
Note: If your Bluetooth audio source device does
not support "simple" pairing and requests a four
digit code, enter '0000'.
• Once a connection has been established, ensure
that T7 is selected as the speaker output. Audio
will now be heard through T7.
2 seconds
Diagram 5
Bluetooth setup
Devices
Bowers & Wilkins T7
5

Publicidad

Tabla de contenido
loading

Tabla de contenido