Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – LuxScape Arm
INSTALLATION
N
ote:
Care must be taken not to set lighting fixture down
on optical lenses or lift the fixture in the lens area
Pole Mount Arm
Tools Required
#2 Phillips head screwdriver
Torque wrench (with a range including 20 ft-lbs to 75 ft-lbs)
3/8" male hex driver (Allen driver) minimum 6" long.
N
ote:
The 3/8" male hex tool is driven with the torque
wrench. Any adaptors needed to use the male hex
tool with your torque wrench are also required.
N
ote:
Avoid using universal joints in the hex driver
assembly to maximize accuracy when applying
torque.
Pole Compatibility (Figure 1)
1.
Use only on 4" or 5" pole diameters.
2.
Check mounting hole pattern on pole. Pattern 'N' is
required.
Mount Bracket (Figure 2)
1.
Place the washers on the socket head capscrews.
2.
Hold the luminaire in place, making sure to line up the
mounting holes.
3.
Assemble socket head capscrews through arm
mounting holes and pole mounting holes. Hand
tighten the socket head capscrews with washers into
the nutplate. (Washers, socket head capscrews, and
nutplate are provided).
4.
First pass- torque both socket head capscrews to 30
ft-lbs.
5.
Second pass- torque both socket head capscrews to 45
ft-lbs.
6.
Third pass- check torque both socket head capscrews
to 45 ft-lbs.
2
Cooper Lighting Solutions
IB500008EN
Installation instructions
3/4" [19mm]
Diameter Hole
Figure 1.
Nut Plate
Flat Washers
Pole
Figure 2.
Wires Routed Through
Center Hole Of "N" Pattern
Pole & Arm Shown In Hidden For Clarity
Figure 3.
2"
[51mm]
7/8" [22mm]
1-3/4"
[44mm]
(2) 9/16" [14mm]
Diameter Holes
LXS Arm
Socket Head Cap Screws
Publicidad
