Manual Settings - Bresser MyTime Easy II Manual De Instrucciones

SETTING AND ACTIVATING ALARM 1 OR 2
1. Press Set1 or Set2 button.
2. Hour display for Alarm1 or Alarm2 will flash. Use the Up or Down button to set the desired hour. Press Set1
or Set2 button to switch to minute display..
3. Minute display for alarm 1 or alarm2 flashes. Use the Up or Down button to set the desired minutes. Press
Set1 or Set2 button to save the settings.
4. Press Alarm1 or Alarm2 button to activate the desired alarm.
5. The alarm sounds at the set time until alarm time is deactivated by pressing the Alarm1 or Alarm2 button
again. When the alarm sounds, press the Snooze / Light button to activate the snooze (ALARM sounds again
after approx. 4 minutes).

MANUAL SETTINGS

1. Press and hold the Mode/Set button for approx. 3 seconds to enter settings mode.
2. Press the Up or Down button to change each setting value.
3. Press the Mode/Set button to switch to the next setting value.
4. Setting values order: DCF time signal on/off - time zone deviation setting (-9 to 9) - time (hours) - time
(minutes) - year - month - day - weekday language setting - Celsius / Fahrenheit (° C / ° F) - key tone on / off
(on / off).