A lifeline that requires the installation structure not to
have a strength above 15 kN, including any safety
coefficient, can be installed between two davimasts,
each equipped with a 150 kg PPE double anchor
GB
with 360° rotation bracket (e.g. a Tractel
temporary lifeline).
IMPORTANT: The operators must ensure their fall
arresters never cross during use.
6.2. blocfor™ 20R and 30R
After a fall, the mechanism of the blocfor™ is locked.
To evacuate the operator up or down, engage the
recovery mechanism by pushing the lock button and
then operate the crank.
The self-retracting fall arrest system blocfor™ 20R
and 30R is equipped with two handles to facilitate its
handling and use in rescue by lifting by holding the
equipment handle with one hand and the crank handle
with the other.
For information on how to use the blocfor™ 20R and
30R device in fall arrest mode, see the blocfor™ EN
360 instructions.
The connection with the PPE anchor point on the
davimast blocfor™ R bracket must be made using an
EN 362 connector. Up to one operator weighing up to
150 kg can connect to this bracket at the same time.
6.2.1. Rescue operation with the blocfor™ R
6.2.1.1. Activating the recovery function
See Figure 4.1.
• (1) Press the red lock button to engage the recovery
function; and
• (2) Pull and turn the crank to recover the operator:
• Clockwise to go up; or
• Anti-clockwise to go down.
6.2.1.2. Return to the fall arrest function
6.2.1.2.1. Rewinding the cable in the device
See Figure 4.2.
When the recovery is complete, rewind the entire cable
into the unit by turning the crank clockwise.
DANGER: Do not disengage the recovery function
from the unit if the cable is not fully wound in the
housing, otherwise the cable may rewind itself at high
speed.
6.2.1.2.2. Disengaging the recovery function
See Figure 4.3.
14
• To disengage the winch mechanism, press the red
button (1) and the crank shaft (2) simultaneously;
• Make sure that the crank handle is positioned
vertically, with the handle at the top so that this
Tempo 3
operation can be carried out; and
®
• Pull the handle (3) before folding it back (4).
DANGER:
Any lifting operation with the blocfor™ R is prohibited.
The winch system is intended for rescue operations
only.
6.3. caRol™ TS
For information on how to use the caRol™ TS winch for
a lifting operation, see the manual "caRol™ - TS-type
hand winch with worm screw".
The connection with the PPE anchor point on the
davimast caRol™ TS bracket must be made using an
EN 362 connector. Up to one operator weighing up to
150 kg can connect to this bracket at the same time.
The following are strictly prohibited:
• Installing or using this product without proper
permission, training and accreditation or, failing that,
without the supervision of an authorised, trained and
accredited supervisor;
• Using this product if any of the markings are illegible;
• Installing or using this product without first verifying
it thoroughly;
• Using this product if it has not undergone a periodic
inspection within the past 12 months by a technician
who has permitted its reuse in writing;
• Connecting a fall arrest system if any of its
components has not undergone a periodic inspection
within the past 12 months by a technician who has
permitted its reuse in writing;
• Using a Tractel
applications other than those described in these
instructions;
• Using this product in contradiction with the information
specified in the section "13. Lifespan";
• Using this equipment as a fall arrest anchor device
for more operators than specified in paragraph 4.2;
• Using this product if the weight of the operator,
including equipment and tools, exceeds 150 kg;
• Using this product with a load ranging from 100 kg to
150 kg (total weight of the operator, equipment and
tools) if any component in the fall arrest system has a
lower safe working weight;
• Using this product if it has arrested a fall;
• Using this product in a highly corrosive or explosive
atmosphere;
7. Prohibited uses
fall arrest anchor device for any
®