Ego Power+ PPX1000 Manual Del Usuario página 14

WARNING:
telescopic power pole is running or with the battery installed.
The attachment connects to the telescopic power pole by means of a coupler device.
1. Switch off the tool and remove the battery pack.
2. Loosen the locking knob.
3. Align the arrow on the attachment shaft with the insert indication on the coupler
and push the attachment shaft into the coupler until you hear a clear "click"
sound. The coupler should be positioned all the way to the LINE on the shaft that
indicates that the attachment is properly mounted into place (Fig. 2).
2
4. Pull the shaft of the attachment to verify that it is securely locked into the coupler.
If not, push the attachment shaft into the coupler until it snaps into place.
5. Tighten the locking knob securely.
WARNING:
knob is fully tightened before operating the equipment. Check it periodically for
tightness during use.
DETACHING THE ATTACHMENT FROM THE TELESCOPIC POWER POLE
1. Switch off the tool and remove the battery pack.
2. Loosen the locking knob.
3. Press the shaft-release button and, with the button depressed, pull the
attachment shaft out of the coupler.
14
56-VOLT LITHIUM-ION TELESCOPIC POWER POLE — PPX1000/PPX1000-FC
Never install, remove, or adjust any attachment while the
To avoid serious personal injury, be certain that the locking
Shaft-Release Button
Locking knob
Insert Indication for
Attachment Shaft
Arrow on the
Attachment Shaft
Line