Getting Started; Batteries; Wall Mount; Remote Sensor - Oregon Scientific BAR310HG Manual Del Usuario

GETTING STARTED

BATTERIES

Insert batteries before first use, matching the polarity (+ and
-). Press RESET after each battery change.
indicates that the batteries are low.
NOTE
Do not use rechargeable batteries. We recommended
that you use alkaline batteries with this product for longer
usage and consumer grade lithium batteries in temperatures
below freezing.

WALL MOUNT

Remove the stand at attach as
1
shown.
2

REMOTE SENSOR

The sensor collects temperature readings approx. every 40
seconds and sends them to the main
collect data from up to 3 sensors.
To set up the sensor:
1. Remove the battery door.
2. Insert the batteries, matching the polarity (+ / -).
Reset after each battery change.
3. Select a channel. Make sure you use a different
channel for each sensor.
4. Close the battery compartment.
5. Place the sensor next to the main unit.
6. Initiate a sensor search on the main unit to start receiving
temperature data from the sensor.
7. Secure the sensor in the desired location using the
table stand or wall mount.
4
unit. The main unit can