Sub Trims - Carson Reflex Wheel ultimate touch 2.0 Manual De Instrucciones

End points
The end points function individually adjusts the low and high
travel limit of each servo on the 4 channels. Set the end points
according to your model mechanics.
• To choose the side of the channel 1 end point to set (steering),
move the steering wheel to the desired low or high side. The
selected side will be highlighted in yellow.
• To choose the side of the channel 2 end point to set (throttle),
move the throttle trigger to the desired low (brake) or high
(acceleration) side. The selected side will be highlighted in
yellow.
• To choose the side of channels 3 or 4 end point to set, usa its
corresponding trim or switch to control it. A trim switch or push
button has to be previously associated with that channel to be
able to control it.

Sub trims

The sub trims function individually adjusts the center position of
each servo of the 4 channels. This is particularly useful when the
servo mechanics doesn't allow an adjustment fine enough. Touch
the channel which sub trim must me adjusted.
Use the wheel to move the red needle and modify the sub trim
value of the selected channel. The position of the corresponding
channel is displayed in real time.
In this example, the channel 2 (throttle) has been selected and the
throttle trigger is half braking. The sub trim of each channel can be
assigned to a trim switch.
GB // 54
In this example, the throttle trigger was moved to it acceleration
side thus selecting the high side end point of the channel 2.
To modify the selected end point, simply touch the corresponding
channel button. The red needle represents the selected side. Use
the wheel to move it and modify the end point value.
The position of the corresponding channel is displayed in real time.
In this example, the acceleration side of the throttle is selected and
the throttle trigger is half accelerating.