Battery Replacement; Specifications - Amprobe ACDC-400 Manual De Uso

battery Replacement (see fig. 9)
� Warning
to prevent electrical shock or meter damage, disconnect the meter's test leads from
any circuit and the meter, then turn the meter off before removing the battery
cover. battery replacement should be performed in a clean environment and with
appropriate care taken to avoid contaminating the meter's interior components.
1. Remove the screw and lift the battery cover.
2. Replace the batteries with the same type (1.5V AAA). note polarity guide below
the battery.
3. Replace the battery cover and screw.

SPECIfICAtIoNS

general Specifications
Display:
Update Rate:
polarity:
power Supply:
Battery life:
Apo Timing:
low battery:
environment:
temperature / Humidity:
operating:
Storage:
Jaw opening:
Dimension :
weight :
Safety lVD: Meets en60101-1:2001; en61010-2-032(2002), Category ii- 600 Volts ac
& dc; pollution degree : 2; class 2
�
eMC: This product complies with requirements of the following european
Community Directives: 89/336/eeC (electromagnetic Compatibility) and 73/23/eeC
(low Voltage) as amended by 93/68/eeC (Ce Marking). however, electrical noise
or intense electromagnetic fields in the vicinity of the equipment may disturb
the measurement circuit. Measuring instruments will also respond to unwanted
3-3/4 digits 4000 counts lCD display
2 per second nominal
Automatic
2 standard 1.5V AAA Size (neDA 24g or ieC
R03) battery
typical 25 hours
idle for 30 minutes
� on lCD; approx. 2.4V
indoor operation, below 2000 m
5°C to 40°C (41°f to 104 °f); < 80% Rh
-10°C to 60°C (14°f to 122 °f); < 80% Rh
27mm max
202 x 70 x 40mm (7.9 x 2.7 x 1.6 in.)
254 gm (0.6 lb)
10