Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To purge the system it is needed to remove the housing of the
pump and to separate the plate with all components of the oil
deposit. Once this action has been done, all the hydraulic system
of the pump can be seen. Release the screw indicated in the
picture. It is also necessary release the spring and the spherical
metal which are inside the hole where we have removed the
screw. Once this has been done, introduce the piece where the
pump takes oil from in a recipient with hydraulic oil and put
the pump into operation (with the forward button of the piston)
until oil goes out and the circuit give up of having air. The purge
process has to make in the right place. It is important to know
that when the pump starts working, the oil is going to get out on
pressure through the hole.
The continuous oil output indicates that there is no air in the circuit and that therefore, it
will be able to return to mount the pump.
Attention! Be careful.
1. Do not wear loose clothing. They could be caught by moving parts of the machine.
2. Always wear gloves.
3. Always use the machine´s accessories because if you don´t do it, could lead to risk of personal
injury.
4. Don't use or manipulate the machine standing in front of it (pipe welding area). User should
always stand at the back of the machine (hydraulic piston area).
5. Place always the forward supporting leg perfectly lined with the hydraulic piston to guarantee
the use safety.
Capacity
Inox/Steel
Work pressure
Voltaje/Frecuency
Forward speed in no-load condition
Forward speed in load condition
Bending time of SS pipe at 90°
Weight
HOW TO PURGE THE HYDRAULIC SYSTEM
SAFETY INSTRUCTIONS
TECHNICAL SPECIFICATIONS
3/8" – 1.1/2"
until 4.5mm
9 Tm
cod. 60090 230V/50Hz
cod. 60091 110V/60Hz
0.63cm/s
0.25-0.35cm/s (with respect to SS bending pipe
AISI 304 – Schedule 10 )
3/8" AISI 304-SCH 10: 31 seconds
1.1/2" AISI 304-SCH 10: 65 seconds
150kg aprox.
7
Publicidad
Tabla de contenido
