4. OPERATING THE DEVICES
4.1 Inserting the battery
Push the battery from above into the battery slot until it locks in place (Figure A�)�
4.2 Removing the battery
Release the lock and remove the battery (Figure B�)�
4.3 Querying the battery status
Press the query button on the battery (Figure C�)�
4.4 Flashlight function of the battery
To switch on the flashlight, press the query button on the battery twice in quick
succession (Figure C�)� To switch it off, press the query button again�
4.5 Switching on and off
To switch on, press the main switch (Figure I�)� The device is ready to operate if
the main switch and workspace lighting are illuminated� To switch off, press the
main switch for three seconds�
4.6 Actuating the star grip valve
The working action is triggered by turning the star grip valve (Figure D�)�
Every rescue device has a deadman function� When the star grip is released,
Every rescue device has a deadman function� When the star grip is released,
it returns to the center/neutral position automatically� This ensures the load is
it returns to the center/neutral position automatically� This ensures the load is
retained�
retained�
4.6.1 Cutting
Turn the star grip valve in the closing direction� (Figure E�)�
Position the cutter as perpendicular as possible to the object to be cut (Figure F�)�
Cut close to the pivot point of the blade (Figure G�)�
4.6.2 Spreading
Turn the star grip valve in the spreading direction (Figure H�)�
Open a small gap at the start, then insert the spreader tips as far into the gap as
possible� Do not spread with the aluminum arms! (Figure J�)�
4.6.3 Pulling
Secure the traction device in the draw hole (6) or on the spreader tips� Actuate the
star grip valve in the closing direction� (Figure E�)�
4.6.4 Squeezing
Only squeeze in the squeezing area and with the squeezing plates of the spread-
er arms (Figure K�)� Actuate the star grip valve in the closing direction� (Figure E�)�
4.6.5 Peeling
Special peeling tips are needed for peeling (Figure L�)� Actuate the star grip valve
in the opening direction� (Figure H�)�
en
es
fr
pt
9