Electrical Safety; Machine Information; Technical Specifications - Ferm AGM1093P Manual Del Usuario

Electrical safety

When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate label.
Class II machine - Double insulation - You
don't need any earthed plug.
If operating a power tool in a damp location is
unavoidable, use a residual current device (RCD)
protected supply. Use of an RCD reduces the risk
of electric shock.

2. MACHINE INFORMATION

Intended use
Your angle grinder has been designed for grinding
masonry and steel materials without the use of
water. For cutting, a special protection guard
must be used (not included)

Technical specifications

Model No AGM1093P AGM1094P AGM1095P
Mains voltage 220-240 V~
Mains frequency
Power input 750W
Rated speed 11.000/min 11.000/min 12.000/min
Wheel disc for grinding
Diameter 100 mm
Bore 16 mm
Spindle thread M10
Weight 1.9 kg
Sound pressure (L )
PA
Acoustic power (L )
WA
Vibration "Surface
grinding" a
h,AG
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
• using the tool for different applications, or with
• the times when the tool is switched off or when
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. Spindle lock button
2. On/Off switch
3. Protection guard
Fig. B
8. Spindle
230-240 V~
9. Mounting flange
10. Wheel disc (not included)
50 Hz
11. Clamping nut
750W 950W
12. Spanner
13. Side handle
Assembly
115 mm 125 mm
22 mm 22 mm
M14 M14
2.0 kg 2.1 kg
Assembling the protection guard
89 + 3 dB(A)
(Fig. A and B)
• Place the machine on a table with the spindle
100 + 3 dB(A)
• Place the protection guard (3) over the
11.2 + 1.5 m/s
2
• Turn the protection guard counter clockwise and
different or poorly maintained accessories,
may significantly increase the exposure level
it is running but not actually doing the job, may
significantly reduce the exposure level.
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
(8) facing upwards.
machine head as shown in Figure C making
sure the ridges on the protection guard fall into
the notches of the machine head.
secure the guard by tightening the screw (14).
7