Publicidad
6. INPUT SOURCE SELECTOR SWICTH
(CH 1 TO 4)
Input source selector switch for channel 1-4:
Button pressed = phono/line (LED lights),
Button released = line (LED off)
7. CHANNEL HIGH CONTROL (CH1 TO 4)
Control HIGH adjusts the high range for
channel 1-4.
8. CHANNEL LOW CONTROL (CH1 TO 4)
Control LOW adjusts the bass range for
channel 1-4.
9. CHANNEL CUE (CH1 TO 4)
Cue button for monitoring channel 1-4 via
headphones.
10. LEVEL (CH1 TO 4)
Volume control for channel 1-4.
11. MIC LEVEL
Volume control for the microphone.
12. MIC ON/OFF
On/off switch for the microphone.
13. LEVEL METER
12-digit LED meter for the stereo master signal.
14. MASTER LEVEL
Volume control for the master output.
15. BOOTH LEVEL
Volume control for the booth output.
16. MIX (CUE)
Control MIX for the monitoring signal for the
headphones.
• Left stop position, CUE: the pre-fader level of
the input channel of which the CUE button is
pressed is monitored.
• Right stop position, PGM: the music program
currently playing is monitored ahead of the
master and booth output controls.
17. HEADPHONES LEVEL
Volume control for the headphones.
18. POWER
Power indicator LED.
19. SELECTOR SWITCH FOR THE HEADPHONES
MONITORING MODE
• Button pressed (SPLIT): the pre-fader level
(mono) is on one side and the output signal
(mono) is on the other side of the headphones.
• Button released: a mixed signal of pre-fader
level and master signal is on both sides of the
headphones.
DMR-400 REAR PANEL
20. POWER INPUT WITH FUSE HOLDER
Used to plug in the supplied power cable.
Only replace the fuse when the device is
disconnected from mains. Only use fuses of the
same rating and power. The correct fuse value
is specified on the rear panel.
21. ON/OFF
Power on/off.
22. GROUND CLAMPING SCREW FOR
TURNTABLES
23. PHONO SENSITIVTY
Gain control for matching the input
amplification of phono inputs to line level
sources.
24. PHONO/LINE SWITCH
Switches between the phono inputs and
line inputs: Button released = phono, Button
pressed = Line.
25. INPUTS (CH1 TO 4)
Stereo inputs for channels 1-4. Connect devices
with line level outputs such as CD players to
inputs LINE 1-8, or turntables with magnetic
systems to inputs PH 1-4.
26. MASTER OUTPUT
Balanced XLR output L/R for connecting
amplifiers or other units with line level input.
27. LINE LEVEL OUTPUT
Stereo output (RCA) for connecting amplifiers
or other units with line level input.
28. BOOTH OUTPUT (XLR)
Balanced XLR output L/R for connecting a
further amplifier, e.g. for the monitoring system
or PA application in a secondary room.
8
Publicidad
