HIKVISION DS-PD2-T10P-WEH Manual De Instrucciones

DS-PD2-T10P-WEH
Wireless 10m Pet Immune PIR Detector
EN50131-2-4:2008
EN50131-1:2006+A1:2009
Security Grade (SG)2
Environmental Class(EC)IV
E N G L I S H
Diagram References
1 PCB Overview
2 LED Indications
3 Microwave Adjustment:0m to 15m
4 Dip Switched 1-4
5 Registration
Please register the device within 90 seconds after it being powered on.
Register Locally
1. Make the security control panel enter the registration mode.
2. Register the detector: Hold the registration key until the three LEDs flash
alternately. The green LED will flash 8 times if the registration is finished.
3. Communication Test: Release the TEMPER spring to trigger the alarm.
Note: The distance between the security control panel and the detector
should be less than 50 cm.
Initialize the Detector
1. Remove the battery to power the detector off.
2. 5s later, hold the registration key and reinstall the battery to power the
detector on at the same time to make the three LEDs start flashing alternately.
Release the registration key while the three LEDs flash once together.
6 Signal Strength Test
7 Inserting the Fixed Mask or Flexible Mask
8 Flexible Mask Adjustment(1)
9 Flexible Mask Adjustment(2)
10
10m Lens Diagram
11 Wall Mounting Bracket ＆ Adapter
12 Wall Mounting Bracket
13
Fixed Bracket
14
Guidelines
Technical Specification
Detectors Technical Characteristics
Detection Range 10m
Detection Angle 90°
Detection Zones 78 zones and 5 planes
Detection Speed 0.25–3m/s
Mounting Height 1.8-2.4m
Two-way Wireless Technology Yes
Blue Wave Technology Yes
Dual Element Pyroelectric Sensor Yes
Tamper Protection Front, rear, and bracket tamper signal input
Intergrated Walk Test Buzzer Yes
Top: Microwave, PIR 1 and alarm
Separated LED Indication
Bottom: PIR 2
Signal Strength Indicators (SSI) Yes
3 Microwave Frequencies to Avoid Interference Yes
Digital Independent Floating Threshold(IFT) Technology
Yes
Plastic Housing Polycarbonate
Animal Immunity
10kg
Optics Sealed
High or low range
Adjustable Sensitivity
0.4mm HDPE in lens area
Lens UV compensated
Detection Method Tri-Signal Detection Logic
Sensor
2 low noise dual element passive infrared sensors and a microwave doppler unit
Environmental and Operating Features
Weatherproof IP55 rated
Certified Operating Temperature -25℃ ~ +60℃(Certified)
Physical Dimensions(H x W x D) 180mm x 80mm x 105mm
Weight 500g
Electrical & battery
Transmission Frequency 868MHz, FM transceiver
Range in Open Space 800m
Battery Type 2x3V Lithium battery (included)
Accessories
Rotatable Wall Mounted Yes – additional wall and fixed brackets available separately
Fixed Wall Mounted Yes – additional wall and fixed brackets available separately
Ceiling Mounted Yes – additional wall and fixed brackets available separately
Battery Additional Battery available separately
Battery Information
The batteries supplied have been chosen to provide long service life whilst,
for safety reasons, having limited output current.
The battery leads must be connected for operation. When disposing of the
product, the battery must be removed and disposed of separately in
accordance with the local regulations.
1
3
4
11 12
3
11 12 13
4
2
5