Potential For Electromagnetic Interference; Troubleshooting - HoMedics BPW-040 Manual De Instrucciones

POTENTIAL FOR
ELECTROMAGNETIC INTERFERENCE
To avoid inaccurate results caused by
electromagnetic interference between electrical
and electronic equipments, do not use the device
near a cell phone or microwave oven.
23
BPW-040_A.indd 25-26 BPW-040_A.indd 25-26

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
POSSIBLE
SYMPTOMS
CAUSES
Replace them
Batteries have
with two new AAA
Unit does not
run down.
alkaline batteries.
turn on when the
START/STOP
Battery polarities Re-insert the
button is pushed.
have been positioned batteries in the
incorrectly. correct positions.
Wrap the cuff
Cuff has been placed
EE measurement
properly so that it is
incorrectly.
error symbol shown
positioned correctly.
on display or the
Did you talk or move
blood pressure
during
Measure again.
value is displayed
measurement?
Keep wrist steady
excessively low
during measurement.
Shaking of the wrist
(or high).
with the cuff on.
E1 error symbol Air circuit
Measure again.
shown on display abnormality.
E2 error symbol Inflation pressure Switch the unit off,
shown on display exceeding 300 mmHg. then measure again.
E3 error symbol Error determining
Measure again.
shown on display measurement data.
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble
or attempt to repair the unit by yourself. Contact
information for HoMedics Consumer Relations Department
can be found on the warranty page (See page 26).
24
CORRECTION
12/22/09 12:37 PM 12/22/09 12:37 PM