Snap-on Drill 11/12/03 8:47 AM Page 4
Keyed Chucks
Open chuck jaws by turning collar with fingers and insert shank of bit
about 3/4" into chuck. Tighten chuck collar by hand. Place chuck key
in each of the three holes, and tighten in CLOCKWISE direction. It's
important to tighten chuck with all three holes to prevent slippage. To
release bit, turn chuck key COUNTERCLOCKWISE in just one hole,
then loosen the chuck by hand. Any authorized Snap-on service
center can install a keyless chuck in place of a keyed chuck.
Keyless Chucks
Open chuck jaws by turning plastic collar with fingers and insert
shank of bit about 3/4" into chuck. Tighten plastic collar CLOCKWISE
while depressing spindle lock button on the right side of the tool
housing (Fig. 4). To release bit, turn plastic collar COUN-
TERCLOCKWISE while depressing the spindle lock button (Fig. 4).
NOTE: DO NOT DEPRESS LOCK BUTTON WHILE OPERATING
DRILL or while the chuck is moving.
Side Handle
CAUTION: Always use side handle and hold drill with both hands.
A side handle is supplied with your drill. It clamps to the front of the
gear case and can be rotated 360 degrees to permit right or left
hand use.
Maintenance
Use only mild soap and damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any part of the tool into a
liquid.
Self-lubricating bearings are used in the tool and periodic
relubrication is not required. In the unlikely event that service is ever
needed, take your tool to an authorized service location.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your distributor or local service center.
ACCESSORY MUST BE RATED FOR USE AT SPEED EQUAL TO
OR HIGHER THAN NAMEPLATE R.P.M. OF TOOL WITH WHICH IT
IS BEING USED.
If you need assistance in locating any accessory, please contact
Snap-on Tools Corporation, Kenosha, WI 53141-1410.
CAUTION: The use of any non-recommended accessory may be
hazardous.
Important
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Full Warranty
Snap-on heavy duty industrial tools are warranted for one year from
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. This warranty does not apply to
accessories or damage caused where repairs have been made or
attempted by others. This warranty gives you specific legal rights and
you may have other rights which vary in certain states or provinces.
In addition to the warranty, Snap-on tools are covered by our:
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your Snap-
on heavy duty industrial tool, simply return it to the participating seller
within 30 days for a full refund. Please return the complete unit,
transportation prepaid. Proof of purchase may be required.
4