Troubleshooting - Kalorik TKG HVC 1001 Manual Del Usuario

EMPTYING AND CLEANING THE DUST CONTAINER & DUST FILTER
• Unplug the vacuum cleaner.
• Press the unlock button on the dust container
• To clean the filter, detach the dust container from the vacuum by swiveling it slightly toward
the "unlock" mark. Remove the filter, clean it with water and let it air dry
Note: Never use the vacuum cleaner without a filter. Do not put the filter in the dishwasher.
• When completely dry, replace the filter in the dust container and secure it firmly.
Important : MAKE SURE THAT THE DUST FILTER HAS COMPLETELY AIR DRIED BEFORE REPLACING IT
BACK IN THE HANDHELD VACUUM CLEANER. Do not dry it with a hair dryer.
• Place the filter back into the dust bin and secure it firmly.
CAUTION: The suction inlet must always be open and unobstructed. Otherwise, the engine
could overheat and be damaged.
Note: To ensure the best efficiency of the vacuum cleaner, it is recommended to empty the
dust container and clean the filter every 5 uses, and to change the filter every 3 to 6 months
TROUBLE SHOOTING
PROBLEM POSSIBLE REASON
The handheld 1. The batteries are discharged
vacuum 2. The batteries are dead or do not
cleaner does charged
not work 3. The connector between the vacuum
cleaner and the charger is dirty
4. There is no current in the wall socket
5. The charger is plugged
6. The system is protected
Power floor 1. The brush is blocked with debris,
brush does strings, etc.
not work 2. The tube is not connected properly
handheld 1. The dust container is full
vacuum 2. The dust filter needs to be cleaned
cannot pick- or replaced
up dust; 3. The device needs to be recharged
suction power
weakened
Dust leak from 1. The dust container is full
handheld 2. The dust filter is not installed correctly
vacuum 3. There is a hole in the dust filter
cleaner
Battery can Battery has reached the end of its life
not be cycles
charged
Strange noises Check that nothing is blocking in the
when the vacuum tube
appliance Check if the dust container is full
works
POSSIBLE SOLUTION
1. Charge the vacuum cleaner
2. Call the consumer service or
dispose of the device
3. Clean the connector
4. Check the fuse and / or
replace it
5. Unplug the charger
6. Reactivate it by plugging in the
charger
1. Remove debris from the brush. If
there is thread blocking the
opening, cut it gently
2. Reconnect the tube properly
1. Empty the dust container
2. Remove the dust bin and check
that no objects are blocking.
Replace the filter if necessary.
3. Charge the device
1. Empty the dust bag
2. Check the installation of the
dust container
3. Replace the filter
Replace the unloaded batteries
into new batteries.
Stop using the device
immediately
Clean the dust filter
If the problem does not vanish,
contact customer service
7
HVC1001-180912