Uline H-1276 Instrucciones De Funcionamiento página 2

9. Proper Dispensing: label releases from the carrier
paper and the front edge of the label is seen by the
sensor of the eye causing the motor to stop. If the
edge of the label is not seen, adjust the direction
of the label advance. Loosen the socket head cap
screw (F) with the larger Allen wrench included and
tilt (D) up or down until the label correctly hits the
sensor. Tighten screw. (See Figure 3)
F
C
10. PROBLEM LABELS: It is not always possible to
advance the label full length. If the eye is set to
advance full length and the label does not have
sufficient body to activate the sensor, it may be
necessary to shorten the label advance by moving
the eye in toward the dispenser. The label is
dispensed by lifting the front edge off the eye and
lifting up slightly as it feeds out so it continues to
clear the sensor. Labels exceeding 3" in length can
be dispensed in the same manner.
11. WASTE CARRIER PAPER REMOVAL: The more carrier
paper winds around the take-up spool, the faster the
movement of the web thru the dispenser. This may or
may not be beneficial to the dispensing operation.
Remove periodically as necessary. It only takes a
few moments when done properly.
PAGE 2 OF 6
OPERATING INSTRUCTIONS CONTINUED
A
E
D
T
Figure 3
CAUTION: We do not recommend pulling out
the spring clip from the take-up spool when
waste is wound around it.
To remove the waste, rotate the roll of waste
counterclockwise on the take-up
spool —reversing its winding direction and
loosening the winding. When sufficiently loose,
pull waste roll away from and off the take-up
spool until the spring clip is exposed and free.
Remove spring clip and balance of waste.
12. Unit will dispense fan-fold computer print-out label
G
forms within its width limitation. Place print-out to rear
of dispenser with label side up to feed bottom of
print-out first. Last label printed is first label removed.
(See Figure 4) Print-out can feed over side collar.
13. Place material to be labeled in a stack directly at
front (delivery end) of machine – affix label with one
hand, remove labeled piece with the other. Stack
addressed material to left of stack of blank material.
Keep the stack high enough to keep movement of
label to a minimum.
1-800-295-5510
uline.com
A
F
C
T
Figure 4
G
E
D
0621 IH-1276