Positioning The Spotlight; Solar Panel; Charging The Battery; Operation - LIVARNO 1020-B Instrucciones De Uso

then slide the Spotlight along the guides to
fix it in place (see Fig. C).
If necessary, adjust the gap between the
„
screw heads and the mounting surface to
provide a firm seating for the Spotlight.
Mounting model 1020-S
Screw the wall bracket
„
by inserting the screws
guide holes into the wall plugs
13
firmly tightening them (see Fig. G).
Fix the Spotlight to the wall bracket
„
loosening the Spotlight star knob
removing the screw
Align the holes in the Spotlight with the
„
holes in the wall bracket and slot the screw
through the holes (see Fig� F)�
12
Screw the Spotlight star knob
„
screw and tighten it hand-tight� Check that
the product is fixed firmly in place.
z Positioning the Spotlight/

solar panel

Positioning model 1020-B
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180° (see
Fig� D)�
Loosen the two Spotlight star knobs
„
adjust the Spotlight (see Fig. B).
When the desired position is obtained,
„
tighten the star knobs again� If necessary,
use a screwdriver to hold the screw while
tightening the star knob�
Positioning model 1020-S
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180° (see
Fig� H)�
Loosen the wall bracket star knob
„
adjust the height of the Spotlight (see Fig�
H)�
When the desired position is obtained,
„
firmly in place
11
through the
7
and
8
by
11
and
9
�
12
onto the
6
to
6
to
10
tighten the star knob again�
Loosen the Spotlight star knob
„
the angle (see Fig� H)�
When the desired position is obtained,
„
tighten the star knob again� If necessary,
use a screwdriver to hold the screw while
tightening the star knob�
Please note: the motion sensor has a field
of view of up to 120°� Make sure that the
motion sensor faces directly towards the
desired detection zone�
Please note: to ensure the solar panel
functions as effectively as possible, make
sure that the surface of the solar panel
not dirty�
Orientation:
The optimum alignment is facing south�
Choose an orientation facing slightly to the
west rather than slightly to the east�
z Charging the battery
The battery is charged in all operating
„
modes� To optimise initial charging, charge
the product while it is turned off�
Please note: the battery is fully charged
after it has been well exposed to sunlight for
7 to 8 hours� The duration of the charging
process depends on the battery's charge
level and the quality of the sunlight�
z Operation
The product can be operated in three
different modes� The operating mode is set
by means of the switch
Please note: the solar panel will turn on the
product in twilight or darkness in the mode
you have set�
Please note: battery charging via the solar
panel does not depend on which mode is
selected� The battery is charged continuously
at all times�
to adjust
9
is
2
�
5
33
GB/MT