Sleep Function; Reattaching The Tail Rudder And Trim Fin - WowWee FlyTech HOVERPOD Guia De Inicio Rapido

enGlisH
Adjusting the trim
Underside of Hoverpod
If your Hoverpod does not move forward in a straight line, you
can adjust the trim by moving the trim fin located on the
underside of Hoverpod, as illustrated . The grooved surface
will help you vary the amount of trim and hold the trim fin
in place .
If your Hoverpod naturally steers to the left, gently move
the trim fin to the left to adjust the steer . If it naturally
steers to the right, gently move the trim fin to the right to
adjust the steer .

Sleep function

If the remote controller is on, but unused for about 5 minutes, that is you are not
controlling or charging Hoverpod, it will enter Sleep Mode . To reactivate the remote
controller, turn it OFF and then ON again .
If Hoverpod does not receive a signal for about 30 seconds the tail rudder will flap
intermittently for about 2 minutes . If it still does not receive a signal it will enter Sleep
Mode . To reactivate it, turn it OFF and then ON again .

reattaching the tail rudder and trim fin

If the tail rudder or trim fin on your Hoverpod becomes loose, you can reattach it .
Reattaching the tail rudder
To reattach the tail rudder verify that the curved edge is at the bottom, then insert the
tail rudder into the socket as illustrated .
Rear of Hoverpod
Apply firm but gentle force .
7