Setting The Clock (Remote Control Only) - Sharp XL-UH240W Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setting the clock (Remote Control only)

XL-UH240W
ENGLISH
In this example, the clock is set for the 24-hour (0:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3
Within 10 seconds, press the
select "CLOCK", and press the MEMORY button.
4
Press the
or
hour display and then press the MEMORY button.
"0:00"
The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00"
The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"AM 0:00"
The 12-hour display will appear.
(AM 0:00 - PM 11:59)
E-13
5
6
To confirm the time display:
[When the unit is in the stand-by mode]
or
button to
Press the CLOCK/TIMER button.
The time display will appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the
time.
button to select 24-hour or 12-
The time display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time
display when the AC power supply is restored after a power failure
or unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" does not
appear in step 3, step 4 (for selecting the 24-hour or 12-hour
display) will be skipped.
To change the 24-hour or 12-hour display:
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 32 for details.]
2 Perform "Setting the clock" from step 1.
Press the
or
button to adjust the hour and
then press the MEMORY button.
Press the
or
button once to advance the time by
1 hour. Hold it down to advance continuously.
Press the
or
button to adjust the minutes and
then press the MEMORY button.
Press the
or
button once to advance the time by
1 minute. Hold it down to change the time in 5-minute intervals.
or
XL-UH240W_8-16.fm
button to display the

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido