Line Out/Cd Changer Connections - Sanyo FXCD-1100 Instrucciones De Operación

Notes
S When using a two speaker installation, the Green, Green/Black, Violet, Violet/Black wires, which
are used for a four speaker installation, are not used. The ends of these wires must be covered
with electrical tape to prevent them from shorting to the unit or the vehicle chassis.
Fuse 15 A
NG
Burnt

LINE OUT/CD CHANGER CONNECTIONS

S The unit has a built in CD changer controller and line output terminals. You can use a compatible Sanyo CD
changer and a separate rear channel amplifier to upgrade your system.
CD Changer DIN Socket
CD Changer
CD Changer DIN Socket
S Connect the 8 pin DIN cable, which is supplied with the AX-300, AX-500 or other compatible Sanyo CD
changer, to the DIN socket on the back of the unit.
RCA Line out Jacks (For Rear Speakers)
S Connect a patch cable (not supplied) from the White (left rear channel) and Red (right rear channel) RCA
line output jacks to the line input terminals of the external amplifier.
S When using a two speaker installation, set
the FADER control to the center position.
S When fuse replacement is necessary re
move the blown fuse by using pliers. Then
install the new 15 amp. fuse.
OK
- 28 -
RCA Line out Jacks
Red
White
(Right) (Left)
External
Amplifier
Rear Speaker