General Operation - Sanyo ECD-T1820 Instrucciones De Operación

GENERAL OPERATION

1
4 5
TURNING THE POWER ON
Install the front panel and press the POWER button
when ACC is on.
TURNING THE POWER OFF
Press the POWER button
to stop the current operation.
The button dims when the power is off (ACC on).
ELECTRONIC CONTROLS
Push the AUDIO button , then Push the AUDIO button  to select the audio functions as shown in the
table below.
Turn the VOL knob  to adjust the selected function ; bass, treble, balance, fade, or volume.
Note
While no other mode is displayed, the VOL knob function as a volume control.
SOUND EFFECT BUTTON
Press the SND Button  for less than 1.5 second.
Each time the button is pressed, the function changes as shown below.
1 FLA (FLAT) 2 ROC (ROCK)
2
3
........................................ 1
......................................... 2
MODE
bAS(bass)
TRE(treble)
bAL(balance)
FAd(fader)
V(volume)
......................................... 3
3 CLA (CLASSIC)
6
...................................... 1
Turn left (Min) Turn right (Max)
Down -5
Down -5
Left L9
Rear R9
Down 0
4 POP (POPS)
-7-
8 7
UP +5
UP +5
Right R9
Front F9
UP 35
5 JAZ (JAZZ) 6 HIP (HIP HOP)