Setting The Temperature; Dry Ironing; Refilling The Water Tank; Vertical Steam Ironing - TEFAL EXPRESS COMPACT ANTI-CALC GV7095 Manual De Instrucciones

página de 133

/ 133
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Use

Steam ironing

• Place the iron's temperature control dial according to the type of fabric to be

ironed (see table below).

• The thermostat light comes on. Be careful ! The steam generator is ready when

the thermostat light goes out and when the green "steam ready" light stays on.

• While ironing, the light on top of the iron and the steam ready light turn on and

off, as the temperature adjusts without interrupting ironing.

• To obtain steam, press on the steam control button under the iron handle and

keep it pressed - fig.5. The steam will stop when you release the button.

• When starting, and regularly while it is being used, your steam generator's

electric pump injects water into the boiler. It makes a noise but this is quite

normal. You may also hear a clicking noise which is the steam valve opening.

Again this is normal.

• Always spray starch onto the reverse side of the fabric to be ironed.

SETTING THE TEMPERATURE ACCORDING TO TYPE OF FABRIC TO BE IRONED:

YPE OF FABRICS

Linen, cotton

Wool, viscose

Synthetics, silk

(polyester, acetate, acrylic, polyamide)

To prime the steam circuit, either be-

fore using the iron for the first time,

or if you have not used the steam

function for a few minutes, press the

steam control button several times in

a row, holding the iron away from

your clothes. This will enable any cold

water to be ejected from the steam

circuit.

Dry ironing

• Do not press the steam control button under the iron handle.

Recommendations : for fa-

brics other than linen or

cotton, hold the iron a few

centimetres from the gar-

ment to avoid burning the

fabric.

Refilling the water tank

• When the red "water tank empty" indicator light turns on, there is no more steam -

The water tank is empty.

• Unplug the steam generator and open the flap on the tank.

• Pour in untreated tap water up to the max mark -

• Replug the generator. Press the "restart" button on the control panel -

ironing. When the green light stops flashing, the steam is ready.

• Iron temperature setting:

- Start with the fabrics to be ironed at a low temperature (•)

and finish with those which need higher temperatures (•••

or Max).

- Mixed fibre fabric: set the ironing temperature to the setting

for the most delicate fabric.

- Woollen garments: press repeatedly on the steam control

button -

placing the iron on the garment itself.

• Set the iron temperature control dial to the MAX position.

• Hang the garment on a coat hanger and hold the fabric slightly taut with

one hand.

As steam is very hot : never attempt to remove creases from a garment

while it is being worn, always hang garments on a coat hanger.

• Holding the iron in a vertical position, tilted slightly forwards, press

repeatedly on the steam control button -

handle) moving the iron from top to bottom -