Hansgrohe Metris E 31440 1 Serie Instrucciones De Montaje página 12

3 mm
3 mm
12
English
Push the spout sealing ring firmly into the spout tee.
Install the spout escutcheon.
Press the spout over the spout tee. Install and
tighten the set screw with a 3 mm Allen wrench.
Do not overtighten the set
screw or the o-rings on the seal-
ing ring will deform, which will
cause a leak.
Turn on the water and check all connections for
leaks.
4-Hole Trim Kits only
Lightly lubricate the diverter o-rings using white
grease (not included).
Press the diverter assembly firmly into the spout tee
until it is fully seated.
Turn the guide bushing so that the slot faces the
rear of the spout.
Install the spout escutcheon.
Firmly press the spout over the tee and diverter.
Tighten the set screw with the included 3 mm Allen
wrench.
Do not overtighten the set
screw or the o-rings on the
diverter will deform, which will
cause a leak.
Install the pull rod. The threaded end of the pull
rod must go into the hole in the pin.