Set Up (Wf 4000 Smart) - Bohler WF 4000 CLASSIC Instrucciones De Uso

3b
TIG DC
Allows the selection of the welding method
2 Step
4 Step
Bilevel
MIG/MAG - Pulsed MIG
Allows the selection of the welding method
2 Step
4 Step
Crater filler
3c
MMA Synergy
Allows you to set the best arc dynamics,
selecting the type of electrode used:
STD
CLS
CrNi
Alu
Cast iron Cast iron
Selecting the correct arc dynamics enables maximum
benefit to be derived from the power source to achieve
the best possible welding performances.
Perfect weldability of the electrode used is not guaran-
teed (weldability depends on the quality of the consum-
ables and their preservation, the operating and welding
conditions, the numerous possible applications, etc.).
TIG DC Current pulsation
CONSTANT current
PULSED current
Fast Pulse
MIG/MAG - Pulsed MIG
Double pulsed
3d
MIG/MAG - Pulsed MIG
Display type
4 VRD Voltage Reduction Device
Shows that the no-load voltage of the equipment is
controlled.
Basic/Rutile
Cellulose
Steel
Aluminium
5 Measurements
During the welding operation, the real current and volt-
age measurements are shown on the LCD display.
5a Welding current
5b Welding voltage

3.7 Set up (WF 4000 Smart)

Permits set up and adjustment of a series of additional param-
eters for improved and more accurate control of the welding
system.
The parameters present at set up are organised in relation to the
welding process selected and have a numerical code.
Entry to set up: by pressing the encoder key for 5 sec.
Selection and adjustment of the required parameter: by
turning the encoder until displaying the numerical code relating
to that parameter. If the encoder key is pressed at this point,
the value set for the parameter selected can be displayed and
adjusted.
Exit from set up: to quit the "adjustment" section, press the
encoder again.
To exit the set up, go to parameter "O" (save and quit) and press
the encoder.
List of set up parameters (MMA)
0 Save and quit
Allows you to save the changes and exit the set up.
1 Reset
Allows you to reset all the parameters to the default
values.
3 Hot start
Allows adjustment of the hot start value in MMA.
Permits an adjustable hot start in the arc striking phases,
facilitating the start operations.
Parameter set as a percentage (%) of the welding current.
Minimum Off, Maximum 500%, Default 80%
7 Welding current
Permits adjustment of the welding current.
Parameter set in Amps (A).
Minimum 3A, Maximum Imax, Default 100A
43