1. AttAch LIght cAgeS to frAMe
Fasten light cord to frame with cable ties
1
2. Secure LIght corD enDS to frAMe.
Create a 4" loop or dip in the light
cord that is lower than plug ends to
allow any condensation to flow away.
3. InStALL LIght buLbS. maximum 150 watts
4. run eLectIrcAL power to the SheLter
Run electrical power to shelter using only a uL approved outdoor power cord.
A. Place the power cord under the cover and plug into male end of the ShelterLite cord.
B. Secure any loose cord to the frame with cable ties.
Cover not shown for illustrative
purposes. Cover may remain on
during installation
Page 2
4" loop
05-14501_14502-OB