Gira 5420 00 Manual De Instrucciones página 8

eNet
Actuador regulador radioeléctrico de 1 elemento mini
Settings, channel
Parameters
Manual commissioning
Operating mode
Local Operation
Manual switch­off of the run­
on time
Switch­on brightness
Switch­on delay
32580702 10499446
Setting options, Basic set­
ting
On, Off
Basic setting: On
Normal operation
Continuous on
Continuous off
Basic setting: Normal Opera­
tion
On, Off
Basic setting: On
On, Off
Basic setting: Off
1...100 %
Basic setting: 100 %
0 s ... 24 h
Basic setting: 0 s
12.03.2014
Explanations
Blocks manual commissioning
for the device channel.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Normal operation
The output can be operated
with radio transmitters and the
Prog button.
Continuous on
The output switches to conti­
nuously "On". All operations of
radio transmitters and the
Prog button are ignored.
Continuous off
The output switches to conti­
nuously "Off". All operations of
radio transmitters and the
Prog button are ignored.
Blocks the output for operation
using the Prog button.
Allows manual switch­off of a
running run­on time. If the pa­
rameter is switched off, then a
switch­off command will also
switch the actuator on. This
parameter is directly connec­
ted to the "Run­on time" para­
meter.
During brief operation, the out­
put switches on at the set
switch­on brightness.
Note: If the value is above the
set maximum brightness or
below the minimum bright­
ness, then the system will
switch to the appropriate limit
value.
The load switches on after a
delay. Repeated switch­on
commands restart the delay ti­
me. If the load has not yet
been switched on due to the
delay when a switch­off com­
mand comes, then the load
will remain off.
Note: The set time apply to
operation using radio transmit­
ters. The device is switched
immediately when the Prog
button is pressed.
8/15