Gira 5420 00 Manual De Instrucciones página 9

eNet
Actuador regulador radioeléctrico de 1 elemento mini
Switch­off delay
Dim up ramp
Dim down ramp
Dimming adjustment time
Run­on time
Behaviour after the end of the
disabling function
32580702 10499446
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
0 s ... 24 h
Basic setting: 0 s
1...60 s
Basic setting: 4 s
0 s ... 24 h
Basic setting: 0 s
On
Off
no change
Last value
Basic setting: No change
12.03.2014
The load switches off after a
delay. Repeated switch­off
commands restart the delay ti­
me. If the load has not yet
been switched off due to the
delay when a switch­on com­
mand comes, then the load
will remain on.
Note: The set time apply to
operation using radio transmit­
ters. The device is switched
immediately when the Prog
button is pressed.
Time between switch­on and
reaching switch­on brightness.
The light is switched on at mi­
nimum brightness and then
dimmed to the switch­on brig­
htness.
Only applies to switch­on with
transmitters (short operation).
If scenes are recalled or swit­
ching uses logic modules, the
switch­on brightness is ap­
proached using so­called soft
dimming (not configurable).
Time until reaching minimum
brightness. The light is dim­
med to minimum brightness
and then switched off.
Only applies to switch­off with
transmitters (short operation).
If scenes are recalled or swit­
ching uses logic modules, the
system switches off directly.
Time from minimum bright­
ness until reaching maximum
brightness (dimming speed).
As soon as a run­on time has
been entered, the actuator will
no longer remain on perma­
nently, but only for the length
of the run­on time. The run­on
time is restarted if actuation is
repeated. This parameter is di­
rectly connected to the "Ma­
nual switch­off of run­on time"
parameter.
Note: The set time apply to
operation using radio transmit­
ters. The device is switched
immediately when the Prog
button is pressed.
Behaviour of the output when
a block is removed.
9/15