Kohler K-7700 Guia De Instalacion página 3

Apply Plumbers
Putty
1. Install the Drain
CAUTION: Never pull on the drain cap to open the drain. Press
and release the drain cap once to close it. Press and release it
again to open it.
Remove the plastic seal from the body.
Apply a 1/2" diameter ring of plumbers putty or other sealant
around the underside of the body according to the sealant
manufacturer's instructions.
Insert the body into the drain hole.
Attach the rubber washer (tapered side up) to the body.
Install the flat washer over the threads on the body.
Partially thread the nut onto the body. Do not fully tighten the
nut at this time.
Orient the "KOHLER" logo as desired prior to fully tightening the
nut. Adjustment is not possible after final assembly.
Wrench tighten the nut.
Apply sealant tape to the top of the tailpiece threads before
screwing it into the body.
Connect the tailpiece to the body.
Remove any excess putty or sealant.
Kohler Co.
Body
Drain Cap
Lavatory
Rubber
Washer
Flat
Washer
Nut
Tailpiece
3 1032033-2-A