Troubleshooting; Specifications - Sony CDP-XA555ES Manual De Instrucciones

Additional Information

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
/Check that the player is connected securely.
/Make sure you operate the amplifier correctly.
/Adjust the playback level using the ANALOG
OUT/PHONE LEVEL control.
/Set the DIGITAL OUT ON/OFF switch to ON
when you make the digital connection.
The CD does not play.
/There's no CD inside the player. Insert a CD.
/Use the stabilizer.
/Place the CD the disc tray correctly with the
label side up on.
/Clean the CD (see page 23).
/Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 23).
The recording level has changed.
/When you connect the amplifier via the
ANALOG OUT (VARIABLE) jacks, the
recording level changes if you adjust the
ANALOG OUT/PHONE LEVEL control on the
player or press ANALOG OUT LEVEL on the
remote during recording.
The remote does not function.
/Remove any obstacles in the path of the remote
and the player.
/Point the remote at the remote sensor g on the
player.
/Replace all the batteries in the remote with new
ones if they are weak.
GB
24

Specifications

Compact disc player
Laser Semiconductor laser (λ = 780 nm)
Emission duration: continuous
Max 44.6 µW*
Laser output
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 2 Hz to 20 kHz ±0.3 dB
Dynamic range More than 100 dB
Harmonic distortion Less than 0.0020 %
Outputs
Jack Maximum
output
type
level
ANALOG OUT Phono
2 V
(FIXED) jacks
(at 50 kilohms)
Phono
ANALOG OUT
2 V
(VARIABLE) jacks
(at 50 kilohms)
DIGITAL Optical
–18 dBm
OUT output
(OPTICAL) connector
DIGITAL Coaxial
0.5 Vp-p
OUT output
(75 ohms)
(COAXIAL) connector
PHONES Stereo
28 mW
phone
jack
General
Power requirements 220 V – 230 V AC, 50/60 Hz
Power consumption 23 W
430 × 126 × 375 mm
Dimensions (approx.)
(w/h/d)
incl. projecting parts
Mass (approx.)
13.2 kg
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
Load
impedance
Over 10 kilohms
Over 50 kilohms
Wave length: 660 nm
75 ohms
32 ohms