Parts List - QualityCraft MM905-48BCP Guia Del Usuario

PArtS liSt:

Fireplace insert...................................................................................................... 1
A) Top panel ........................................................................................................ 1
B) Base panel ...................................................................................................... 1
C) Back panel ...................................................................................................... 1
D) Bottom support panel ...................................................................................... 1
E) Side panels ..................................................................................................... 2
F) Left side panel ................................................................................................. 1
G) Right side panel ............................................................................................... 1
W) KD screws ..................................................................................................... 48
X) Plastic connectors ......................................................................................... 16
Y) SELF REPAIR SET
Touch-up repair paint (bottle) ........................................................................... 1
L shape bracket ............................................................................................... 2
Screws for L shape .......................................................................................... 8
Plastic connector ............................................................................................. 1
KD screws ....................................................................................................... 3
KD nuts ........................................................................................................... 3
THIS FIREPLACE REQUIRES 1 – 2 PEOPLE TO ASSEMBLE AND NORMALLY TAKES 45 MINUTES – 1 HOUR TO
COMPLETE.
TOOL REQUIRED: PHILLIPS HEAD SCREWDRIVER
MANtEl ASSEMBlY:
CAUTION: Place a piece of cardboard or protective sheet on the floor in order to avoid
scratching the decorative surface of your mantel during assembly.
Please DO NOT fully tighten the KD screws until all panels are assembled.
Step 1: Attach 16 plastic connectors [X] to panels A, B, C and D with 32 KD screws [W]
as shown in Fig. A. (2 KD screws for each plastic connector).
NOTe: If the KD screw(s) do not fit during assembly, loosen the 2 screws to adjust the
plastic connector until the panels/KD screws can be installed.
Step 2: Attach panels E to panel B with 4 KD screws. Attach panel D to panel B with 2
KD screws. See Fig. B.
2
Fig. A fRONT
Fig. B fRONT