Publicidad
Idiomas disponibles
Idiomas disponibles
12. Re-install foam, carpet and trim.
13. Using 10mm Socket, install new screw included with kit
into bracket and trim.
14. Install Speaker Panel, refer to Service Manual for proper
installation/removal steps.
Corvette Windbreak
ALL INFORMATION WITHIN ABOVE
DATE
BORDER TO BE PRINTED EX-
ACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GMSPO SPECIFICATIONS.
REVISION
AUTH
15. Using Phillips Head Screwdriver and screws included in kit,
install brackets to both sides of the Windbreak as shown.
Do not fully tighten screws as adjustment may be needed to
ensure proper alignment.
Note: Brackets are left and right hand specific.
16. Close tonneau and install Windbreak as shown. If bracket
and slots line up, the Windbreak is properly installed and
technician should tighten bracket screws. If bracket and
slots do not line up, adjust bracket accordingly then tighten
bracket screws. Once Windbreak is properly installed,
Corvette logo should be visible from rear of vehicle.
REV 22AU08
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Corvette Windbreak
PART NO.
88966629
6200 Grand Pointe Dr., Grand Blanc, MI 48439
88966629
SHEET
4
SHEET
4
15
OF
15
OF
Publicidad
