Yamaha MM1242 Manual De Operación página 8

0 PHONES jack
Connect the headphones here.
You can monitor the following signals:
— Signals available for monitoring —
1. Post-EQ signal
(when the corresponding channel PFL switch is ON)
2. Pre-fader ST signal
(when the corresponding stereo L/R PFL switch is ON)
3. Pre-AUX SEND 3/4-fader signal
(when the corresponding AUX send 3/4 PFL switch is
ON)
Downloaded from: http://www.usersmanualguide.com/
A MONITOR control
B PHONES LEVEL control
C AUX SEND 3, 4 PFL switches
D AUX SEND 3, 4 faders
SUM INV
(+V)
PFL
SUM INV
(+V)
PFL
SUM
SUM
(+V)
(ST OUT)
PFL
SUM
+
SUM INV
SUM
+
This control adjusts the level of the signal output from the
MONITOR OUT.
The PHONES control adjusts the level of the signal sent to
the PHONES jack.
Turning this switch ON will allow you to monitor the
signal output to AUX SEND 3 and 4 via the MONITOR
OUT or headphones.
These faders adjust the AUX SEND 3 and 4 output levels.
You can also use these to adjust the level of an auxiliary
output.
METER
L
(MONITOR)
STEREO OUT
METER
R
(MONITOR)
INV
AUX SEND
1,2 +4dB
AUX SEND 1
METER
INV
AUX SEND
3,4 +4dB
INV
L
MONITOR
MONITOR
OUT +4dB
INV
R
INV
PHONES
LEVEL
INV
+4dB
5