Wiring Diagram - Vivotek AE2101 Manual Del Usuario

IV

Wiring Diagram

Shown below is the wiring diagram for the window demister. A spare 6-way terminal block
is provided at the rear of the chassis for additional camera and lens connections.
TB.1 6 way terminal block
TB.2 3 way terminal block
FTB.1 Fused terminal block
STAT.1 18 C Thermostat
°
STAT.2 35 C Thermostat
°
H.1 Heater
PSU Power Supply Unit
P.C.B.1 Thermal control
circuit board
FS.1 3 Amp. Fuse
DC Output of PSU Connectors
1. Pins 1, 2, 3, and 4 are DC 12V output for motor lens, siren, or speaker connecitons. If
they are not connected, remove cables from the connectors.
2. Pins 5 and 6 are DC 12V output for camera.
Pins 1 & 2
12V Output
Pins 3 & 4
12V Output
STAT.1
H.1
or
B.2
STAT.2
TB.2
PCB.1
Pins 5 & 6
DC for camera
H1. Heater
H1, Heater
STAT.1 TURN OFF at 28°C
STAT.1 TURN OFF at 28 C
TURN ON at 18°C
TURN ON at 18 C
B2. Blower
STAT.2 TURN OFF at 25°C
B2, Blower
TURN ON at 35°C
STAT.2 TURN OFF at 25 C
TURN ON at 35 C
12VDC X4
3.5A or 5A
CHASSIS EARTH
CHASSIS EARTH
Lines for
heater & blower
4
O
O
TB. 1
O
O
24VAC or
PSU
80~260VAC Input
FTB. 1 FS. 1
COVER EARTH
COVER EARTH