Radio Inputs; Storing New Codes; End Of Programming - V2 ELETTRONICA PD1 Instrucciones

INSERTING THE WISHED CODES INTO THE MEMORY
To memorize the wished TX codes follow carefully the instructions.
• Press the UP or DOWN keys and select the wished radio input, the display will show (Example) tEL1
• Press the MENU key, the display will show trAS
The control unit is ready for the radio learning
• Press the wished remote control key until the display shows rEC
• Release the remote control key.
The control unit is now ready to learn new codes.
SUBSTITUTION OF A SINGLE CODE
To substitute a single code already memorized, it's sufficient proceed as explained above.

END OF PROGRAMMING

This menu allows to finish the programming (both default and
personalized) saving the modified data into memory.
no further corrections to carry out: do not quit the
programming
Si end of programming
THE INSERTED DATA HAVE BEEN MEMORIZED: THE CONTROL
UNIT IS READY TO BE USED.
25

RADIO INPUTS

To each memorized code one of
the available four radio inputs is
associated, in order to give the
control unit the wished command;
furthermore with simple and fast
operations it is possible to carry
out the partial or total clearing of
the codes present in memory.
The connection of a modular super
heterodyne receiver, allows the
use of the four radio channels,
tEL1 tEL2 tEL3 tEL4, to each a
command of the control unit is
associated:
tEL1 START: transmitting the
code associated to tEL1, the
control unit receives a START
tEL2 PEDESTRIAN START:
transmitting the code associated
to tEL2, the control unit receives a
PEDESTRIAN START
tEL3 STOP: transmitting the
code associated to tEL3, the
control unit receives a STOP
tEL4 COURTESY LIGHTS:
transmitting the code associated
to tEL4, the control unit activates
the COURTESY LIGHTS output.