SPALDING M620022 Manual Del Usuario página 12

3.
While maintaining alignment of dimple and trough, bounce top and middle pole
assembly (9 and 10) onto bottom pole section (11) using a wood scrap as
shown. Bounce until the top and middle pole assembly (9 and 10) is aligned
with the marked line on the bottom pole (11).
You should have a 3 1/2" (8,9 cm) of overlap when properly assembled.
CAUTION!
WHEN PROPERLY POUNDED
TOGETHER, THE POLE SECTIONS
SHOULD HAVE A 3-1/2" (8,9 CM)
OVERLAP.
IMPORTANT!
Align dimple of middle pole section (10) into
trough of bottom pole section (11) as shown.
10
MIDDLE POLE
DIMPLE
TROUGH
MARKED LINE
11
BOTTOM POLE
ID# M6611742 07/08
HOLE
MARK LINE
3 1/2"
(8,9 cm)
12
9
TOP POLE
10
MIDDLE POLE
11
BOTTOM POLE
Wood Scrap
(not supplied)