Cleaning And Care; Noise Development - Clatronic HT 3393 Instrucciones De Servicio

4. Insert the plug into a duly installed 230 V/50 Hz protective contact socket.
5. Shift the switch on the handle to one of the desired heat/blowing levels:
Switch-off
After use shift the switch to position „0" and pull out the plug. Leave the device to cool before
putting it away! To this purpose place the device on one side of the housing or hang it up by
the suspension lug.
• Before cleaning remove the mains lead from the socket.
• Clean the housing with a soft, dry cloth without additives.
WARNING: The device must never be immersed in water!
mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the device, as over time this may result in the cable
breaking.
• Check the mains cable regularly for damage.
Air Intake Grill
• Please clean the grill on the air intake side of the hairdryer regularly in order to avoid
GB
excessive temperatures as a result of heat accumulation.
• Remove any dirt that is present. If necessary, a fine brush can be used.
The sound pressure level in the ear of an operator (LpA) was measured according to DIN
EN ISO 3744.
Sound pressure level detected: 87 dB(A) (no limit)
30
3393.indd 30
Level 0: off
Level 1: medium airflow and medium temperature
Level 2: strong airflow and high temperature

Cleaning and care

Noise development

M
P
P
P
N
T
m
w
S
P
P
p
T
h
T
e
I
lo
08.07.2010 12:15:0