About Oregon Scientific; Fcc Statement - Oregon Scientific BAR898HGA Manual Del Usuario

Power
Main unit
Remote sensing unit
Weight
Main unit :
Remote sensing unit
Dimensions
Main unit
Remote sensing unit
ABOUT OREGON SCIENTIFIC
Visit our website (www.oregonscientific.com) to learn more
about Oregon Scientific products. If you're in the US and
would like to contact our Customer Care department di-
rectly, please visit:
http://www2.oregonscientific.com/service/default.asp
OR
Call 1-800-853-8883.
For international inquiries, please visit:
www2.oregonscientific.com/about/international.asp
P/N: 086L002778-078 REV1
15/47
(23.48 to 31.01 inHg)
:uses four (4) UM-3 or "AA"
1.5V batteries
:uses two (2) UM-3 or "AA"
1.5V batteries
10.6 oz (30 g)
(without battery)
: 2.8 oz (80 g)
(without battery)
:7.68 x 4.13 x 3.03 inches
or 95 (L) x 105 (W) x 77 (T) mm
:4.13 x 2.76 x .83 inches
or 105 (L) x 70 (W) x 21 (T) mm

FCC STATEMENT

This device complies with Part 15 of the FCC Rules.Op-
eration is subject to the following two conditions: (1)This
device may not cause harmful interference, and (2)This
device must accept any interference received, including
interference that may cause undesired operation.
WARNING
Changes or modifications not expressly ap-
proved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE
This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accord-
ance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turn-
ing the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
14