Battery Level - REVELL NANO QUAD Manual Del Usuario

english
The thrust controller (the left controller on the remote control) must point down before being
switched on (1A). Then set the ON/OFF switch of the remote control to the „ON" position; the
Power LED will flash red (1B). The LEDs begin to blink when the Quadrocopter is switched on.
Place the helicopter on the ground so that the tail points towards the pilot (1C). The Quadrocopter
needs a few seconds to initialise the gyro and to establish the connection to the remote control.
As soon as the LEDs on the Quadrocopter light up red permanently, the connection to the remote
control has been established.
Attention! Always place the Quadrocopter on an even horizontal surface – the control electronics
aligns its neutral position to the subsurface!
note: Only minimal corrections of the controls are necessary for a smooth flying behaviour of
the Quadrocopter! The direction information applies if the Quadrocopter is viewed from behind. If
the Quadrocopter is flying towards the pilot, it must be moved in the opposite direction.
2A
In order to start or gain altitude, carefully move the left hand joystick forward.
Move the left hand joystick back for landing or to fly lower.
2B
To fly forward, carefully move the right hand joystick control forward.
To fly backward, pull the right joystick back carefully.
2C
Curve left by carefully moving the right hand joystick control to the left.
Curve right by carefully moving the right hand joystick control to the right.
2D
Turn the Quadrocopter around to the left by moving the left joystick to the left.
Turn the Quadrocopter around to the right by moving the left joystick to the right.

BAttery level:

• If the LED „eyes" blink, the battery is depleted. Commence with landing immediately in order
to avoid crashing!
The correct trim is a basic requirement for fault-free flying behaviour of the Quadrocopter. Its
adjustment is simple, but it requires some patience and a feel for it. Please observe the following
instructions precisely: Carefully move the thrust control up and raise the Quadrocopter approxi-
mately 0.5 to 1 metre in altitude.
3A If the Quadrocopter moves by itself slowly or quickly to the left or right ...
Press the roll trim incrementally in the opposite direction.
3B If the Quadrocopter moves by itself slowly or quickly forwards or backwards ...
Press the nick trim down incrementally. If the helicopter moves backwards, press the nick trim up
incrementally.
If the Quadrocopter moves by itself slowly or quickly around its own axis ...
land and leave the left hand joystick in the null position for 3 sec. - the trim adjustment takes
place automatically.
1 START pREpARATION
2 FlIGHT CONTROl
3 TRIM ADJUSTMENT OF THE CONTROl