Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and Operating Instructions
VDOME/HB-K1
(Art. No. 92565)
Heater & Blower Kit 24VAC for VKCD-1329/IR and
VKCD-1331
1. Safety Instructions
• Read these safety instructions and the operation manual first before you install
and commission the camera.
• Keep the manual in a safe place for later reference.
• Protect your camera from contamination with water and humidity to prevent it
from permanent damage.
Never switch the camera on when it gets wet. Have it checked at an authorized
service center in this case.
• Never operate the camera outside of the specifications as this may prevent the
camera functioning.
• Do not operate the cameras beyond their specified temperature, humidity or
power ratings.
• Operate the camera only at a temperature range of -10°C to +50°C and at a
humidity of max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug. Never pull the
cord itself.
• Pay attention when laying the connection cable and observe that the cable is not
subject to heavy loads, kinks, or damage and no moisture can get in.
• Do not attempt to disassemble the camera board from the dome.
• The warranty becomes void if repairs are undertaken by unauthorized persons.
Do not open the camera housing.
• Never point the camera towards the sun with the aperture open. This can destroy
the sensor.
• Installation, maintenance and repair have to be carried out only by authorized
service centers.
Before opening the cover disconnect the unit from mains input.
• Contact your local dealer in case of malfunction.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• Do not use strong or abrasive detergents when cleaning the dome.
Use a dry cloth to clean the dome surface.
In case the dirt is hard to remove, use a mild detergent and wipe gently.
• All openings provided in the housing for assembly purposes must be closed
and/or sealed.
• The installer is responsible for ensuring that the degree of protection as
per the technical specifications is upheld, e.g. by using all enclosed gasket
seals and O-rings, by waterproofing the cable exits with silicon or through
laying the cable in such a way that the cable does not act as a „gutter".
• During assembly, care must be taken to ensure that existing seals are
correctly inserted and are not displaced as a result of assembly.
You must not continue to use damaged seals.
NOTE: This is a class A digital device. This digital device can cause harmful
interference in a residential area;
in this case the user may be required to take appropriate corrective
action at his/her own expense.
2. Parts supplied
• Fan and Heater Module
• 2x Screw, PH M2x14
• Screw, PH M3x4
• Installation and Operating Instructions
3. Main Features
• ON/OFF Switching: +5°C / +10°C (Heater)
• Power Consumption: 10W (Heater) / 0,7W (Blower)
• Not usable for 12VDC Supply Voltage
4. Installation
Heater
Fan
PH M2x14
eneo
is a registered trademark of Videor E. Hartig GmbH
®
Excl. distribution through specialised trade channels only.
Videor E. Hartig GmbH
Carl-Zeiss-Straße 8 · 63322 Rödermark/Germany
Tel. +49 (0) 6074 / 888-0 · Fax +49 (0) 6074 / 888-100
www.videor.com
PH M3x4
Technical changes reserved
© Copyright by Videor E. Hartig GmbH
03/2010
Publicidad
