Accessories And Spare Parts; Warranty; Symbols On The Device; Device Description - Kärcher Battery Power Manual De Instrucciones

Notes on the content materials (REACH)
Current information on content materials can be found
at: www.kaercher.com/REACH

Accessories and spare parts

Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.

Warranty

The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)

Symbols on the device

Symbols on the quick charger
Protect the device from moisture.
Store the device in a dry place. Do
not subject the device to rain. The
device is only suitable for indoor
use.
The battery pack is being charged,
the indicator lamp is flashing.
The battery pack is fully charged,
the indicator lamp lights up contin-
uously.
The device meets the require-
ments of protection class II.

Device description

Illustration A
Battery terminals
1
Battery mount
2
Indicator lamp
3

Wall attachment

4
Mains cable socket
5
8
Charging process for a standard charger
Note
The operating state of the battery pack can be read off
the battery pack display.
The display symbols are described in the battery pack
operating instructions.
If the display does not show anything during charging,
the battery capacity is fully depleted or very low. Display
shows remaining charging time once the battery pack is
sufficiently charged.
1. Plug the mains cable in the mains cable socket.
Illustration B
2. Plug the mains plug into the socket.
3. Push the battery pack into the mounting on the
charger.
Illustration C
The charging process begins automatically.
Indicator light lights up green.
The battery pack display shows the remaining
charging time. The display shows 100% and the in-
dicator lamp lights up green continuously when the
battery pack is fully charged.
4. Remove the battery pack from the charger after
charging.
5. Pull the mains plug out of the socket.
Note
The charged battery pack can remain in the charger un-
til it is used. There is no danger of overcharging.
Avoid unnecessary energy consumption and unplug the
charger when the battery pack is fully charged.
Wall attachment
The device is suitable for wall attachment. Information
on the weight of the device is provided in the "Technical
data" chapter.
1. Check the load capacity of the wall before installa-
tion.
2. Keep the mains plug freely accessible. Hole dis-
tance = 26 mm.

Transport and storage

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transport
and storage.

Care and service

The device is maintenance-free.
 Regularly check the battery terminals for soiling.
 Clean dirty battery terminals.
 Check the ventilation slits for soiling, clean if neces-
sary.
 Occasionally recharge battery packs stored for a
longer period.
English

Operation